CLI Guide

Table 23. Details of eventfilters (continued)

NOTE: idrac.all.all is not a valid sub category.

Valid Severity values are:

● Critical

● Warning

● Info

Valid examples of alert queries are:

● idrac.alert.all

● idrac.alert.audit

● idrac.alert.audit.lic

● idrac.alert.audit.warning

● idrac.alert.audit.lic.critical

This command does not support setting the proxy parameters if the share location (-l) is HTTP/HTTPS.

For more information, see Proxy parameter section.

Input

● get—Displays the list of eventfilter settings

● set—Configures the actions and notifications for a given eventfilter configuration

● -i—Message ID for which the simulation is needed

● -c—Alert category of the specific event filter

● -a—The action that must be invoked when the event occurs. Valid values are none, powercycle,

power off, or systemreset

● -n—The notification is sent when the event occurs. Valid values are all, snmp, ipmi, ws-events,

redfish-events, oslog, email, remotesyslog, or none. You can append multiple notifications

that are separated by a comma. You cannot enter the values all or none with other notifications. If

incorrect notification is specified along with other valid notifications, the valid and invalid notification

set is failed.

● -r—Event generation interval. This option is applicable only to the temperature statistics subcategory

tmps. You can use this option as a stand-alone or with -n and -a.

NOTE: If both event generation interval and notifications are configured and there is an error while

configuring the notifications, the event generation interval is not set. The valid values are 0–365. 0

disables the event generation.

Example

● Display all available event filter configurations.

racadm eventfilters get -c idrac.alert.all

● Display eventfilter configurations for a specific category. For example, audit

racadm eventfilters get -c idrac.alert.audit

● Display eventfilter configurations for a specific subcategory. For example, licensing under the audit