CLI Guide

Table 68. Details of infinibandstatistics (continued)
Single Collision Frames Transmitted: Not Applicable
Multiple Collision Frames Transmitted: Not Applicable
Late Collision Frames Transmitted: Not Applicable
Excessive Collision Frames Transmitted: Not Applicable
Link Status: Down
Link Width: Not Available
Link Speed: Not Available
Partition Link Status: Up
Partition Driver State: Operational
NOTE: When Port, Partition or RDMA statistics are not available, the output displays No Port/
Partition/RDMA Statistics found for FQDD <Infiniband FQDD>.
inlettemphistory
Table 69. Details of inlettemphistory
Description
Displays the average and the peak temperatures during the last hour, day, week, month, or year. Also
Exports the inlet temperature history data file. The file can be exported to a remote file share, local file
system, or the management station.
NOTE: For FM120x4 systems, this subcommand provides the historical data for system board
temperature.
Synopsis
● racadm inlettemphistory get
racadm inlettemphistory export -f <Filename> -u <username> -p <password>
\
-l <location> -t <export file type>
racadm -r <idrac ip> -u <idrac username> -p <idrac password>
inlettemphistory\
export -f <Filename> -u <username> -p <password> -l <location> -t
<export file type>
●
This command does not support setting the proxy parameters if the share location (-l) is HTTP/HTTPS. To
perform the operation with HTTP or HTTPS through a proxy, the proxy parameters must be first
configured using the lifecyclecontroller.lcattributes. Once these proxy parameters are configured, they
become the part of default configuration; the proxy attributes should be cleared to end use of the HTTP/
HTTPS proxy.
The valid lifecyclecontroller.lcattributes HTTP/HTTPS proxy parameters are:
● UserProxyUserName
● UserProxyPassword
● UserProxyServer
●
UserProxyPort
● UserProxyType
To view the list of proxy attributes, use racadm get lifecycleController.lcAttributes.
Input
● -f — Exports inlet temperature history filename. The maximum length of this parameter is 64
characters.
NOTE: If a file with the specified filename exists, then the older file is replaced with the new history
file.
● -u — User name of the remote share to export the file. Specify user name in a domain as domain or
username.
● -p — Password for the remote share to where the file must be exported.
92 RACADM Subcommand Details