CLI Guide

Table 70. Details of jobqueue (continued)
● --realtime — Specifies the real time job.
NOTE:
○ --realtime is applicable for storage configuration commands run on
PowerEdge servers with PERC 9 or newer storage controllers. To check if the
controller supports realtime capability, run storage get controllers -o -
p RealtimeConfigurationCapability command.
○ -r option is not valid for real time configuration.
Example
● View jobs in the current job queue.
racadm jobqueue view
● View status of a specific job ID.
racadm jobqueue view -i <JobID>
● Issue configuration changes for a PowerEdge RAID controller then start a real time job to
execute the changes.
racadm set RAID.Slot.3-1.RAIDdefaultWritePolicy WriteBack
racadm set RAID.Slot.3-1.Name “Prod Workload”
racadm jobqueue create RAID.Slot.3-1 –realtime
● Delete all possible jobs from the current job queue.
racadm jobqueue delete --all
● Delete a specific job from the current job queue.
racadm jobqueue delete -i <JobID>
● To clear all the jobs in the job queue.
racadm jobqueue delete –i JID_CLEARALL
● Create a Job for the provided FQDD and add to the job queue.
racadm jobqueue create NIC.Integrated.1-1 -r pwrcycle -s
TIME_NOW -e 20120501100000
NOTE:
As RACADM does not support warm boot job creation, you will not observe
any LCL messages.
● Create a real time configuration job for the specified RAID controller.
racadm jobqueue create RAID.Integrated.1-1 -s TIME_NOW --
realTime
RAC1024: Successfully scheduled a job.
Verify the job status using "racadm jobqueue view -i
JID_xxxxx" command.
Commit JID = JID_927008261880
● Create a commit job for InfiniBand objects.
racadm jobqueue create <InfiniBand FQDD>
krbkeytabupload
Table 71. details of krbkeytabupload
Description
Uploads a Kerberos keytab file to iDRAC.
RACADM Subcommand Details 95