Owners Manual

Figure 38. Removing the intrusion switch

Next steps

1. Install the intrusion switch.

2. Follow the procedure listed in After working inside your system.

Installing the intrusion switch

Prerequisites

1. Follow the safety guidelines listed in Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Remove the air shroud.

4. Remove internal MiniPERC riser.

Steps

1. Align the intrusion switch with the intrusion switch slot.

2. Slide the intrusion switch until it is firmly seated in the intrusion switch slot.

3. Connect the intrusion switch cable to the connector on the system board.

Installing and removing system components