Manualshelf

Users Guide

ManualsBrandsDell ManualsAX NodesEMC XC Core XCXR2
301302303304305306307308309310
Viewing vFlash SD card properties using web interface
To view the vFlash SD card properties, in the iDRAC Web interface, go to Configuration > System Settings > Hardware
Settings > vFlash. The Card Properties page is displayed. For information about the displayed properties, see the iDRAC Online
Help.
Viewing vFlash SD card properties using RACADM
To view the vFlash SD card properties using RACADM, use the get command with the following objects:
● iDRAC.vflashsd.AvailableSize
● iDRAC.vflashsd.Health
● iDRAC.vflashsd.Licensed
● iDRAC.vflashsd.Size
● iDRAC.vflashsd.WriteProtect
For more information about these objects, see the iDRAC RACADM CLI Guide available at https://www.dell.com/idracmanuals.
Viewing vFlash SD card properties using iDRAC settings utility
To view the vFlash SD card properties, in the iDRAC Settings Utility, go to Media and USB Port Settings. The Media and
USB Port Settings page displays the properties. For information about the displayed properties, see the iDRAC Settings Utility
Online Help.
Enabling or disabling vFlash functionality
You must enable the vFlash functionality to perform partition management.
Enabling or disabling vFlash functionality using web interface
To enable or disable the vFlash functionality:
1. In the iDRAC web interface, go to Configuration > System Settings > Hardware Settings > vFlash.
The SD Card Properties page is displayed.
2. Select or clear the vFLASH Enabled option to enable or disable the vFlash functionality. If any vFlash partition is attached,
you cannot disable vFlash and an error message is displayed.
NOTE: If vFlash functionality is disabled, SD card properties are not displayed.
3. Click Apply. The vFlash functionality is enabled or disabled based on the selection.
Enabling or disabling vFlash functionality using RACADM
To enable or disable the vFlash functionality using RACADM:
racadm set iDRAC.vflashsd.Enable [n]
n=0
Disabled
n=1
Enabled
NOTE:
The RACADM command functions only if a vFlash SD card is present. If a card is not present, the following message
is displayed: ERROR: SD Card not present.
Managing vFlash SD card 309