Owners Manual

Figure 57. Removing the hard drive from the hard drive carrier
Next step
If applicable, install the hard drive into the hard drive carrier.
Installing a hard drive into the hard drive carrier
Prerequisite
Follow the safety guidelines listed in Safety instructions.
CAUTION
: Mixing hard drives from previous generations of XC Series servers is not supported.
Steps
1 Insert the hard drive into the hard drive carrier with the connector end of the hard drive towards the back of the carrier.
2 Align the screw holes on the hard drive with the screws holes on the hard drive carrier.
When aligned correctly, the back of the hard drive is ush with the back of the hard drive carrier.
3 Using the Phillips #1 screwdriver, replace the screws to secure the hard drive to the hard drive carrier.
100
Installing and removing system components