Owners Manual
CAUTION: To avoid damage to the battery connector, you must rmly support the connector while installing or removing a
battery.
2 Use a plastic scribe to pry out the system battery as shown in the following illustration:
Figure 64. Removing the system battery
3 To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4 Press the battery into the connector until it snaps into place.
Figure 65. Installing the system battery
Next steps
1 Install the expansion card riser 1A.
2 If applicable, connect the cables to the expansion card(s) in the expansion card riser 1A.
3 Follow the procedure listed in After working inside your system.
4 While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
5 Enter the correct time and date in the System Setup Time and Date elds.
6 Exit the System Setup.
USB module
An additional USB port can be added to the front of the system. Depending on the conguration of your system, you can add either a USB
3.0 or USB 2.0 module. The USB module cable connects to the internal USB port on the system board.
Removing the USB module
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the backplane cover.
4 Remove the air shroud.
106
Installing and removing system components