Owners Manual

NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route these cables
properly when you replace them to prevent them from being pinched or crimped.
NOTE: The procedure to remove the USB 3.0 and USB 2.0 modules is similar.
Steps
1 Disconnect the USB cable from the USB connector on the system board. For more information, see System board jumpers and
connectors.
2 Using Phillips #1 screwdriver, remove the screws on the USB module.
3 Slide the module out of the system until it is free of the USB module slot on the front panel.
Figure 66. Removing the USB module
Next step
Install the USB module.
Installing the USB module
Prerequisite
Follow the safety guidelines listed in Safety instructions.
NOTE
: The procedure to install the USB 3.0 and USB 2.0 modules is similar.
Steps
1 Route the USB cable on the USB module, through the USB slot on the front panel.
2 Insert the USB module into the slot on the front panel.
3 Align the screw on the module with the screw hole on the system.
4 Using the Phillips #1 screwdriver, replace the screw to secure the module to the system.
5 Route the USB cable and connect it to the USB connector on the system board. For more information, see System board jumpers and
connectors
.
Installing and removing system components
107