Owners Manual

Figure 73. Installing the system board
Next steps
1 Install the Trusted Platform Module (TPM).
NOTE
: The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
2 Replace the following:
a Integrated storage controller card
b USB 3.0 module (if applicable)
c IDSDM/vFlash card
d All expansion card risers
e Processors and heat sink modules
f Processors and memory blanks (if applicable)
g Memory modules and memory module blanks
h Network daughter card
i Air shroud
j Power supply unit(s)
3 Reconnect all cables to the system board.
NOTE
: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4 Follow the procedure listed in After working inside your system.
5 Ensure that you:
a If the Service Tag is not backed up in the backup ash device, enter the Service Tag manually.
b Update the BIOS and iDRAC versions.
c Re-enable the Trusted Platform Module (TPM). For more information, see Replacing the Trusted Platform Module.
116
Installing and removing system components