Owners Manual

Figure 79. Removing the cable cover
3 Using Phillips #1 screwdriver, remove the screws that connect the control panel to the system.
Figure 80. Removing right control panel
4 Holding the control panel by its sides, remove the control panel away from the system.
Next step
Install the right control panel.
Installing the right control panel
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Route the control panel cable through the side wall of the system.
2 Align the control panel with the control panel slot on the system and attach the control panel to the system.
3 Connect the control panel cable to the system board and secure it using cable latch.
4 Using Phillips #1 screwdriver, install the screw that secures the control panel to the system.
Installing and removing system components
121