Owners Manual
Removing the BOSS card
About this task
CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of
the system.
2 Open the system cover.
3 Locate the BOSS card on the system board.
CAUTION: To prevent damage to the card, you must hold the card by its edges only.
4 After ensuring that the PCIe bracket is unobstructed, lift the card to remove it from the connector on the system board.
Figure 86. Removing the BOSS card
1
BOSS-S1 card 2 card connector on the system board
Removing the M.2 SSD module
About this task
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell EMC is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
Steps
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
BOSS card
133