Owners Manual
Figure 88. Installing the M.2 SSD module
1 module connector (2) 2 screw (2)
3 module (2)
Installing the BOSS card
About this task
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
NOTE
: It is recommended that you always use a static mat and static strap while working on components inside the system.
2 Open the system cover.
3 Hold the card by its edges and align the card connector with the connector on the system board.
CAUTION
: To prevent damage to the card, you must hold the card by its edges only.
4 Press the card-edge down until the card is fully seated.
5 Close the system cover.
6 Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
BOSS card
135