Owners Manual

Steps

1 If removed, install the expansion cards into the expansion card riser.

2 Holding the touch points, align the expansion card riser with the connector and the riser guide pin on the system board.

NOTE: While installing riser 1 B, press the tabs and hold the touch point to align the expansion card riser and the riser guide

pin on the system board.

3 Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.

Figure 37. Installing the expansion riser 1A

Figure 38. Installing the expansion riser 2A

Next steps

1 Follow the procedure listed in After working inside your system.

2 Install any device drivers required for the card as described in the documentation for the card.

Installing and removing system components