Owners Manual

Removing an expansion card from the expansion card riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, remove the air shroud.
4 If applicable, disconnect the cables from the expansion card.
NOTE: When removing a card from the riser 1, open the PCIe card holder latch. If applicable, remove the PCIe guide and then
remove the expansion card.
Steps
1 If applicable, lift the expansion card latches out of the slot.
2 Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
Figure 39. Removing an expansion card from riser 1A
Installing and removing system components
85