Owners Manual

Removing a micro SD card

Prerequisites

1 Follow the safety guidelines listed in Safety instructions .

2 Follow the procedure listed in Before working inside your system .

Steps

1 Locate the SD card slot on the IDSDM module, and press the card to partially release it from the slot.

2 Hold the SD card and remove it from the slot.

NOTE: Temporarily label each SD card with its corresponding slot number after removal.

Next step

Install a micro SD cards .

Installing a micro SD card

Prerequisites

Follow the safety guidelines listed in Safety instructions.

NOTE

: To use an SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.

NOTE: Re-install the micro SD cards into the same slots based on the labels you had marked on the cards during removal.

Steps

1 Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and insert the contact-pin end of the

card into the slot.

NOTE

: The slot is keyed to ensure correct insertion of the card.

2 Press the card into the card slot to lock it into place.

Next step

Follow the procedure listed in After working inside your system.

Removing the IDSDM/vFlash card

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

3 If you are replacing the IDSDM/vFlash card, remove the micro SD card.

NOTE

: Temporarily label each micro SD card with its corresponding slot number after removal.

Steps

1 Locate the IDSDM/vFlash connector on the system board.

To locate IDSDM/vFlash, see System board jumpers and connectors.

2 Holding the pull tab, lift the IDSDM/vFlash card out of the system.

Installing and removing system components