Owners Manual

Figure 46. Installing IDSDM/vFlash card

Next steps

1 Install the micro SD card.

NOTE

: Re-install the micro SD cards into the same slots based on the labels you had marked on the cards during removal.

2 Follow the procedure listed in After working inside your system.

Network daughter card

The network daughter card (NDC) is a small, removable mezzanine card, which provides the exibility of selecting dierent network

connectivity options.

Removing the network daughter card

Prerequisites

1 Follow the safety guidelines listed in Safety instructions.

2 Follow the procedure listed in Before working inside your system.

3 Remove the expansion card riser 2 or the rear hard drive cage, depending on the conguration of your system.

Steps

1 Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.

2 Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.

3 Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.

Installing and removing system components