Owners Manual

Figure 47. Removing the network daughter card

Next step

Install the network daughter card.

Installing the network daughter card

Prerequisite

Follow the safety guidelines listed in Safety instructions.

Steps

1 Orient the NDC so that the Ethernet connectors t through the slot in the chassis.

2 Align the captive screws at the back-end of the card with the screw holes on the system board.

3 Press the touch points on the card until the card connector is rmly seated on the system board connector.

4 Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.

Installing and removing system components