Owners Manual

Figure 48. Installing the network daughter card
Next steps
1 Install the expansion card riser 2 or the rear hard drive cage, depending on the conguration of your system.
2 Follow the procedure listed in After working inside your system.
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for the primary storage controller card. The storage controller
card provides the storage subsystem for internal hard drives of your system. The controller supports SAS and SATA hard drives.
Removing the integrated storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the expansion card riser 1.
Steps
1 Using Phillips #2 screwdriver, loosen the screws that secure the integrated storage controller cable to the connector on the system
board.
2 Lift the integrated storage controller cable to disconnect it from the connector on the system board.
Installing and removing system components
93