Dell Data Protection
10 Administrator Guide
Interactive Installation/Upgrade and Activation
To install/upgrade and activate the client software, follow the steps below. You must have an administrator account to
perform these steps.
NOTE: Before you begin, save the user’s work and close other applications; immediately a
fter the installation is complete, the computer will
need to restart.
1
Open the Dell-Data-Protection-<version>.dmg file located in the Dell installation media and open the installer.
The following message displays:
This package will run a program to determine if the software can be installed.
2
Click
Continue
to proceed.
3
Read the Welcome text and click
Continue
.
4
Review the license agreement, click
Continue
, and then click
Agree
to accept the terms of the license agreement.
5
In the
Domain Address:
field, enter the fully qualified domain for the target users, such as
department.organization.com
.
6
In the
Display Name (optional):
field, consider setting the
Display Name
to the NetBIOS (pre-Windows 2000) name of
the domain, which is typically in uppercase.
If set, this field is displayed instead of the Domain Address in the
Activation
dialog. This provides consistency with the
domain name shown in
Authentication
dialogs for domain managed Windows computers.
7
In the
Device Server
: field, enter the Dell Device Server host name.
If your deployment uses a non-default configuration, update the port fields and
Use SSL
check box.
Once a connection is established, the Dell Device Server connectivity indicator changes from red to green.
8
In the
Policy Proxy:
field, the Dell Policy Proxy host name is auto-populated with a Dell Policy Proxy host that matches
the Dell Device Server host. This host is used as the Dell Policy Proxy if no hosts are specified in the policy configuration.
After a connection is established, the Dell Policy Proxy connectivity indicator changes from red to green.
9
Once the
Dell Data Protection Configuration
dialog is complete and connectivity has been established to the Dell
Device Server and Dell Policy Proxy, click
Continue
to show the installation type.
10
Some installations on specific computers display a
Select a Destination
dialog before the
Installation Type
dialog
displays. If so, select the current system disk out of the list of disks displayed. The current system disk’s icon displays a
green arrow pointing to the disk. Click
Continue
.
11
After the installation type displays, click
Install
to continue with the installation.
12
When prompted, enter the administrator account credentials (required by the Mac OS X Installer application), then
click
OK
.
NOTE: Immediately after the installation is complete, you must restart the computer. If you have open files in other applications and are not
ready to restart, click Cancel, save the work, and close the other applications.
13
Click
Continue
Installation
. The installation begins.
14
When the installation completes, click
Restart
.