User guide

Licensed Customer Confidential Installing RedirectorSink on Clustered Exchange Servers
Email Continuity Administrator Guide version 6.5 (1st ed.) 59
4 Confirm actions.
a. Confirm that the action or actions are correct. If so, click Next.
This begins the process of copying files, registering the
RedirectorSinks with the Exchange environment, setting up registry
entries, providing the RedirectorSinks with information about the
RedirectorControllers, and stopping and restarting the IIS SMTP
service.
NOTE Save the Log
To save the log, click Save. The RedirectorManager software queries the
Exchange servers and retrieves information regarding their configuration. A
RedirectorSink does not initialize after the IIS SMTP restart until it processes the
first piece of mail. Therefore, it may take several minutes for the main page to
reflect the running version and correct installation status of the event sink.
b. Click Done.
TIP Force Load of RedirectorSinks
If the RedirectorManager or Administration Console do not show the
RedirectorSinks as installed on a server, send an email message to any user on
that server. This causes Exchange to load the RedirectorSink. While not
typically an issue on production servers under load, this can occur in test
environments.
Upgrading RedirectorManager
The installation process can be used to install an upgrade; however, you must
stop and start IIS before the upgrade takes effect. The upgrade installs any new
files, but does not change any existing registry entries.
Each time you add a new Exchange server to your environment, or when you
reinstall an existing Exchange server, you must repeat the RedirectorSink
installation process to install the RedirectorSink on the new or reinstalled server.
When reinstallation is necessary, the Administration Console displays an alert
message.
Installing RedirectorSink on Clustered Exchange
Servers
To install RedirectorSink on clustered Exchange servers:
1 Copy the RedirectorSink folder over to the passive node of the Exchange
Server.
2 Launch setup.exe, follow the prompts, and allow the install to complete.
3 Restart the SMTP service on the passive node.