Setup Guide

Broadcom OCM-CLI-LPE-UG124-100
38
Emulex OneCommand Manager Command Line Interface User Guide
5.3.2 DeleteAuthConfig
This command deletes the authentication configuration on LPe12000-series adapters only.
NOTE: The RemoveAuthConfig command is deprecating this command.
Supported By
Linux, Solaris, and Windows
Syntax
DeleteAuthConfig <WWPN1> <WWPN2> <PasswordType> <Password>
Parameters
5.3.3 GetAuthConfig
This command retrieves the authentication configuration for the adapter.
Supported By
Linux, Solaris, Windows, and Windows + CIM Provider on a VMware host
Syntax
GetAuthConfig <WWPN1> <WWPN2>
Parameters
5.3.4 GetAuthStatus
This command returns the current status for the authentication connection specified by WWPN1 and WWPN2 (adapter and
the switch). It includes the current authentication state (connected or failed). Currently authenticated connections specify the
hash algorithm and DH group used in the DHCHAP associated with this connection. Failed status includes the failure reason.
Supported By
Linux, Solaris, Windows, and Windows + CIM Provider on a VMware host
Syntax
GetAuthStatus <WWPN1> <WWPN2>
Parameters
WWPN1 The WWPN of an FC function.
WWPN2 Either use ff:ff:ff:ff:ff:ff:ff:ff for a switch or use the WWPN for a target.
PasswordType 1 = ASCII
2 = Hexadecimal (binary)
3 = Password not yet defined
Password The current password value.
WWPN1 The WWPN of an FC function.
WWPN2 Either use ff:ff:ff:ff:ff:ff:ff:ff for a switch or use the WWPN for a target.
WWPN1 The WWPN of an FC function.
WWPN2 Either use ff:ff:ff:ff:ff:ff:ff:ff for a switch or use the WWPN for a target.