Setup Guide

Broadcom OCM-CLI-LPE-UG124-100
39
Emulex OneCommand Manager Command Line Interface User Guide
5.3.5 InitiateAuth
This command initiates the authentication configuration on the adapter.
Supported By
Linux, Solaris, Windows, and Windows + CIM Provider on a VMware host
Syntax
InitiateAuth <WWPN1> <WWPN2>
Parameters
5.3.6 RemoveAdapterAuthConfig
This command removes or deletes all authentication configuration entries for an FC adapter.
NOTE:
 This command deletes the authentication configuration, including secrets, from the adapter flash memory. You
must reload the driver or reboot the system to activate the new driver settings.
 This command is not supported on LPe12000-series adapters.
Supported By
Linux, Solaris, Windows, and Windows + CIM Provider on a VMware host
Syntax
RemoveAdapterAuthConfig <WWPN>
Parameters
5.3.7 RemoveAuthConfig
This command removes or deletes one or more authentication configuration entries for an FC port.
NOTE: Use the AuthConfigList command to get the list of entity pairs.
Supported By
Linux, Solaris, Windows, and Windows + CIM Provider on a VMware host
Syntax
removeAuthConfig <WWPN> <Entity pair 1> <Entity pair 2> <Entity pair N>
Parameters
WWPN1 The WWPN of an FC function.
WWPN2 Either use ff:ff:ff:ff:ff:ff:ff:ff for a switch or use the WWPN for a target.
WWPN The WWPN of the port whose configurations you want to delete.
WWPN The WWPN of the FC port whose configuration you want to delete.