Setup Guide

Broadcom OCM-CLI-LPE-UG124-100
92
Emulex OneCommand Manager Command Line Interface User Guide
Syntax
hbacmd nvme-list <WWPN> [Target WWPN]
Parameters
Example
hbacmd nvme-list 10:00:00:90:fa:5d:05:a9
Information similar to the following is displayed:
Discovered NVMe Subsystems for 10:00:00:90:fa:5d:05:a9
NVMe Qualified Name : nqn.2014-08.com.example:nvme.host.sys.xyz
Port WWN : 50:06:01:60:90:20:5C:38
Controller ID : 0x0001
Model Number : NVMfxx999
Serial Number : 0123456789
Firmware Version : 1.2.0.1
Total Capacity : 1 TB
Unallocated Capacity: 500 GB
Configured NVMe Subsystems for 10:00:00:90:fa:5d:05:a9
NVMe Qualified Name : nqn.2014-08.com.example:nvme.host.m32
Port WWN : 30:16:01:62:90:21:CC:41
Controller ID : 0x0001
Model Number : NVMf0103
Serial Number : 0123456789
Firmware Version : 1.2.0.5
Total Capacity : 2 TB
Unallocated Capacity: 400 GB
5.13.10 nvme-list-ctrl
The nvme-list-ctrl command displays the controllers for a specified NVMe target.
Supported By
Linux and Windows
Syntax
hbacmd nvme-list-ctrl <WWPN> <Target WWPN> <NQN> [NSID]
Parameters
NOTE: Only the controllers on the subsystem specified in the command line are displayed. Controllers for other
subsystems are not displayed, even if they reside within the same NVME target WWPN.
WWPN The WWPN of the FC initiator port.
Target WWPN The WWPN of an FC port on an NVMe-capable device (optional).
WWPN The WWPN of the FC initiator port.
Target WWPN The WWPN of an FC port on an NVMe-capable device.
NQN The qualified name of the NVMe subsystem.
NSID The namespace identifier (optional), in hexadecimal. Use it to list only controllers attached to the specified namespace.