Setup Guide

Broadcom OCM-CLI-LPE-UG124-100
99
Emulex OneCommand Manager Command Line Interface User Guide
5.15.1 GetTrunkInfo
The GetTrunkInfo command displays the following trunking configuration information for LPe35002 and LPe35004
adapters.
 Trunking status (enabled or disabled)
 Trunking type (two-lane, 4-lane)
 List of physical links comprising each trunk
 Status of each physical link comprising the trunk (active or down)
 Aggregated links speed for each trunk
Supported By
Linux, Windows, and Windows + CIM Provider on a VMware host
Syntax
GetTrunkInfo <WWPN>
Parameters
5.15.2 SetTrunkMode
The SetTrunkMode command specifies the type of trunking to use on LPe35002 and LPe35004 adapters.
Supported By
Linux, Windows, and Windows + CIM Provider on a VMware host
Syntax
SetTrunkMode <WWPN> <trunking mode>
Parameters
5.16 vPort Commands
The vPort Commands group manages virtual ports and functions on FC adapters.
NOTE: In Linux, vPorts do not persist across system reboots. vPorts must be re-created after a system reboot.
5.16.1 CreateVPort
This command creates a virtual port with an automatically generated WWPN or a user-specified virtual WWPN on the
specified physical port. If you specify auto, the virtual WWPN is generated automatically. Otherwise, you must specify the
virtual WWPN for this parameter. If creation is successful, the WWPN is displayed as part of the output from the command.
The vname optional parameter can be specified for the virtual port’s name.
WWPN The WWPN of a physical or trunked port.
WWPN The WWPN of a physical or trunked port.
trunk mode 0 = Disable trunking
1 = Two-lane trunking
2 = Four-lane trunking