Users Guide

Broadcom DRVLin-UG128-100
42
Emulex Drivers for Linux User Guide
5.4.2 FC Error Log Messages and Their Descriptions
The following table lists the FC error log messages and their descriptions.
LOG_EVENT 0x00010000 CT, TEMP, DUMP, logging
LOG_FIP 0x00020000 FIP events
LOG_FCP_UNDER 0x00040000 FCP underruns errors
LOG_SCSI_CMD 0x00080000 ALL SCSI commands
LOG_NVME 0x00100000 NVME general events
LOG_NVME_DISC 0x00200000 NVME discovery/connect events
LOG_NVME_ABTS 0x00400000 NVME ABTS events
LOG_NVME_IOERR 0x00800000 NVME I/O Error events
LOG_EDIF 0x01000000 External DIF events
LOG_AUTH 0x02000000 Authentication events
LOG_ALL_MSG 0xFFFFFFFF LOG all messages
Table 8: FC Error Log Messages and Their Descriptions
0111: Dropping received ELS cmd
The driver decided to drop an ELS Response ring entry.
Data: (1) ulpStatus (2) ulpWord[4] (3) ulpTimeout
Severity: Error
Log: Always
Action: This error could indicate a software driver or firmware issue. If this issue persists, report these errors to Broadcom Technical
Support.
0113: An FLOGI ELS command <elsCmd> was received from DID <did> in Loop Mode
While in Loop Mode, an unknown or unsupported ELS command was received.
Data: None
Severity: Error
Log: Always
Action: Check the device DID.
0115: Unknown ELS command <elsCmd> received from NPORT <did>
Received an unsupported ELS command from a remote N_Port.
Data: None
Severity: Error
Log: Always
Action: Check the remote N_Port for a potential issue.
0125: FDISC Failed (x%x). Fabric out of resources
The fabric rejected an FDISC because the switch cannot support additional virtual ports.
Data: lsRjtError
Severity: Error
Log: Always
Action: Reconfigure the switch to support more NPIV logins. If this issue persists, contact Broadcom Technical Support.
Table 7: Message Log Table (Continued)
LOG Message Verbose Mask Definition Verbose Bit Verbose Description