Users Guide

Broadcom DRVLin-UG128-100
81
Emulex Drivers for Linux User Guide
1432: Failed to initialize rpi headers.
Failed to initialize RPI headers.
Data: None
Severity: Error
Log: LOG_INIT
Action: None required.
1476: Failed to allocate sysfs attr
Failed to allocate sysfs attrIbutes.
Data: None
Severity: Error
Log: LOG_INIT
Action: None required.
1477: Failed to set up hba
Failed to set up the HBA.
Data: None
Severity: Error
Log: LOG_INIT
Action: None required.
1603: Loopback test did not receive expected data length. actual length <len>expected length <full_-
size>.
The loopback test did not receive the same amount of data that it transmitted.
Data: None
Severity: Error
Log: LOG_LIBDFC
Action: None required.
1800: Could not issue unreg_vpi
Driver attempt to unregister VPI failed.
Data: None
Severity: Error
Log: LOG_VPORT verbose
Action: Software driver error. If this issue persists, report these errors to Broadcom Technical Support.
1801: Create vport work array FAILED: cannot do scsi_host_get
The driver was unable to get a reference to a SCSI host.
Data: None
Severity: Warning
Log: LOG_VPORT verbose
Action: Software driver warning. If this issue persists, report these errors to Broadcom Technical Support.
1816: FLOGI NPIV supported, response data <port>
The fabric reports support for NPIV upon FLOGI.
Data: (1) response_multiple_NPort
Severity: Warning
Log: LOG_VPORT verbose
Action: No action needed, informational.
Table 8: FC Error Log Messages and Their Descriptions (Continued)