Users Guide

Broadcom OCM-APP-LPE-UG124-100
64
Emulex OneCommand Manager Application
User Guide
7.11 Viewing Maintenance Information
NOTE: This option is not available in read-only mode.
Use the Maintenance tab (Figure 33) to view firmware information and update adapter firmware. You can also configure
boot from SAN and change WWPN and WWNN information for the selected adapter port.
To view firmware information, perform these steps:
1. Select the Host or Fabric view.
2. Select a port in the discovery-tree.
3. Select the Maintenance tab (Figure 33).
Figure 33: Maintenance Tab
The following Maintenance tab fields are displayed:
 Firmware area:
– Active Firmware Version – The Emulex firmware version number for this port.
– Service Processor FW Name – The Emulex firmware name for this port.
– Firmware Version on Flash – The flash firmware version currently being used by the adapter.
– ULP FW Name – The firmware version running on the ULP processors within the ASIC.
– Adapter Boot Version – Displays one of the following:
 The selected adapter port's boot code version if the boot code is present.
 Disabled if the boot code is disabled.
 Not Present if the boot code is not loaded. If the boot code is not loaded, Enable adapter boot is not visible, and
you cannot configure the selected port to boot from SAN.
– Enable adapter boot – Select this option if you want the port to load and execute boot code during system startup.
– Click Configure Boot to configure boot from SAN (not available in read-only mode).