Users Guide

Broadcom OCM-APP-LPE-UG124-100
65
Emulex OneCommand Manager Application
User Guide
NOTE: Enabling adapter boot only causes the port to load the boot code and run it during system startup. It does not mean
that the port boots from SAN. To boot from SAN, the boot type must be enabled. Enable this in the Boot from SAN
configuration window for each boot type. (See Section 7.17.5, Configuring Boot from SAN.)
 WWN Management area:
NOTE: The WWN Management area is disabled when FA-PWWN is enabled on an adapter port.
– Current:
 WWPN – The World Wide Port Name for the selected port.
 WWNN – The World Wide Node Name for the selected port.
– Pending Changes:
 WWPN – Works with the Change WWN button. It displays the WWPN that you assigned for the selected port, but
the system must be rebooted for these changes to take effect and appear under the Current listing. See
Section 7.16, Changing the WWPN and WWNN, for more information.
 WWNN – Works with the Change WWN button. It displays the WWNN that you assigned for the selected port, but
the system must be rebooted for these changes to take effect and appear under the Current listing. See
Section 7.16, Changing the WWPN and WWNN, for more information.
For LPe12000-series adapters, the tab includes a Download Firmware button. For instructions on updating firmware on a
port of an LPe12000-series adapter, see Chapter 8, Updating Adapter Firmware.
7.12 Viewing Target Information
When you select a target associated with an adapter from the discovery-tree (Figure 4), the Target Information tab
(Figure 34) displays information associated with that target.
To view target information, perform these steps:
1. Select the Host, Fabric, or Virtual Port view.
2. In the discovery-tree (Figure 4), select the target whose information you want to view. The Target Information tab
appears (Figure 34).