Users Guide

Broadcom OCM-APP-LPE-UG124-100
71
Emulex OneCommand Manager Application
User Guide
7.14.1.3 Binding a Target That Does Not Appear in the Persistent Binding Table
NOTE: It is possible to specify a SCSI bus and target that have already been used on behalf of a different FC target.
Attempting to bind a target already in the Persistent Binding table on the Target Mapping tab results in the
following error message:
Target already in target list.
To bind a target that does not appear in the Persistent Binding table on the Target Mapping tab, perform these steps:
1. Select the Host or Fabric view.
2. In the discovery-tree (Figure 4), select the FC function you want to set up with persistent binding.
3. Select the Target Mapping tab (Figure 36). All targets are displayed.
4. Click Bind New Target. The Bind New Target dialog is displayed (Figure 38).
Figure 38: Bind New Target Dialog
5. Select the type of binding that you want to use, and type the WWPN, WWNN, or D_ID that you want to bind to the target.
6. Select the Bus ID and Target ID that you want to bind, and click OK.
NOTE: A target does not appear on the target list if automapping is disabled and the target is not already persistently
bound.
7.15 Masking and Unmasking LUNs (Windows)
LUN masking refers to whether a LUN is visible to the operating system. A masked LUN is not available and is not visible to
the operating system. You can use the LUN Masking tab (Figure 39) to mask or unmask LUNs at the host level.
NOTE: The LUN Masking tab is not shown in the Virtual Port view because LUN masking is not available for virtual ports.