Setup Guide

Broadcom LPe-HBA-IG128-100-2CS
7
Emulex Fibre Channel Host Bus Adapters Installation Guide
Figure 6: Removing the Mounting Bracket
5. Remove the mounting bracket, and store it for future use.
6. Align the new mounting bracket tabs with the holes in the HBA.
CAUTION! Be careful not to push the mounting bracket past the grounding tabs on the transceiver housing. Make sure the
LEDs are properly aligned with the holes in the mounting bracket.
7. Reinstall the screws and washers that attach the HBA to the mounting bracket.
8. Reinstall the transceiver by sliding it into the housing. When the latch engages, it clicks.
9. Push the bail back into place.
2.1.2 Setting the Secure Firmware Feature
The LPe31000-series and LPe32000-series HBAs have a jumper that enables or disables the Secure Firmware feature as
required.
To update the firmware using a tool, such as the Emulex HBA Manager application, boot utilities, or Elxflash utilities, there
is no need to remove the jumper. The Secure Firmware feature can remain enabled as long as the update is from one secure
firmware version to another secure firmware version. To change the firmware version from a secure firmware version to an
unsecured firmware version, you must remove the jumper before updating the firmware.
NOTE: The Emulex OneCommand
®
Manager application has been renamed as the Emulex HBA Manager application.
Replace the jumper after the firmware update is complete.
Figure 7 provides an example of a common location of the Secure Firmware jumper.