Users Guide

Broadcom OCM-VM-LPe-UG124-101
106
Emulex OneCommand Manager for VMware vCenter User Guide
Authentication group –
Commands to configure
DHCHAP authentication
between the adapter and the
switch.
 setauthconfigsecret
 setauthconfigparams
 removeauthconfig
 removeadapterauthconfig
 authconfiglist
 getauthconfig
 getauthstatus
 initiateauth
setauthconfigsecret – Sets the local or remote secret on
the adapter for an authenticated connection to the switch.
setauthconfigparams – Sets one or more authentication
configuration parameters for the FC port
removeAuthConfig – Removes or deletes one or more
authentication configuration entries for an FC port.
removeadapterauthconfig – Removes or deletes all
authentication configuration entries for an adapter.
authconfiglist – Retrieves the authentication configuration
for the specified entity pair.
getauthconfig – Retrieves the authentication configuration for
the specified entity pair.
getauthstatus – Returns the current status for the
authentication connection specified by WWPN1 and WWPN2.
initiateauth – Initiates the authentication configuration on
the adapter.
Boot group – Commands to
enable an ESXi host to manage
the boot environment.
 enablebootcode
 getbootparams
 setbootparam
enablebootcode – Enables or disables the bootBIOS state on
a given port.
getbootparams – Fetches the boot parameters for a given port
and given boot type.
setbootparam – Fetches the boot parameters for a given port
and given boot type
Cluster group – Commands
that can be run on a cluster.
 exportsaninfo
 firmwareupdate
 listhbas
exportsaninfo – Exports SAN information related to Emulex
adapters in all the hosts in a cluster.
firmwareupdate – Updates the firmware on the Emulex
adapters found in a VMware cluster or the ESXi host.
listhbas – Lists manageable Emulex adapters.
Diagnostic group – Commands
to run diagnostic tests for an
Emulex adapter or port.
 D_Port
 echotest
 fctraceroute
 getbeacon
 getxcvrdata
 loadlist
 loopbacktest
 posttest
 setbeacon
D_Port – Runs D_Port diagnostics. Also known as ClearLink.
echotest – Runs an echo test on a port.
fctraceroute – Issues an FC trace route request for the
communication path between an FC initiator port and an FC
target port.
getbeacon – Shows the current beacon state for a port on an
adapter.
getxcvrdata – Shows the transceiver data, such as vendor
name and serial number.
loadlist – Lists the flash memory load list data for an FC port.
loopbacktest – Runs a loopback test on a port.
posttest – Runs a POST on a specified FC port.
setbeacon – Turns the beacon state on or off for an adapter port
and sets the beacon’s duration.
Table 4: Help Groups and Supported CLI Commands (Continued)
Help Group Supported CLI Commands Command Descriptions (Continued)