Users Guide

Broadcom OCM-VM-LPe-UG124-101
109
Emulex OneCommand Manager for VMware vCenter User Guide
12.3.1.2 reset
This command resets the adapter. An adapter reset can require several seconds to complete, especially for remote devices.
When the reset is completed, the system command prompt is displayed.
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password> h=<esx_host> reset <WWPN>
Parameters
12.3.1.3 version
This command displays the version of the CLI installed.
Syntax
elxvcpcmd.exe version
Parameters
None.
12.3.2 Attribute Commands
The Attribute commands show and update CIM information, port information, adapter attributes, PCI data, and server
attributes. These commands also enable a port on a host and set the physical port speed.
12.3.2.1 enablefecstate
This command enables or disables FEC on the specified adapter.
NOTE: Not supported on LPe12000-series adapters.
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password> h=<esx_host> enablefecstate <WWPN>
[Flag]
Parameters
v The vCenter server IP address.
u The user name for the vCenter server.
p The user password for the vCenter server.
h The IP address of the ESXi host.
WWPN The WWPN of the port.
v The vCenter server IP address.
u The user name for the vCenter server.
p The user password for the vCenter server.
h The IP address of the ESXi host.
WWPN The WWPN of the HBA.
Flag 0 = Disable FEC state.
1 = Enable FEC state.