Users Guide

Broadcom OCM-VM-LPe-UG124-101
129
Emulex OneCommand Manager for VMware vCenter User Guide
12.3.7.9 setbeacon
This command turns the beacon on or off and sets the beacon’s duration.
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password> h=<esx_host> setbeacon <WWPN>
<BeaconState>[BeaconDuration]
Parameters
12.3.8 Driver Parameter Commands
The Driver Parameter commands show, set, and save driver parameter values. You can also change the parameters back
to factory default values.
12.3.8.1 driverconfig
This command sets all driver parameters to the values in the .dpv file on a particular ESXi host. The .dpv file’s driver type
must match the driver type of the host platform adapter.
Syntax
elxvcpcmd.exe v=<vcenter_server> u=<vc_username> p=<vc_password> h=<esx_host> driverconfig <WWPN>
<FileName> <Flag>
Parameters
v The vCenter server IP address.
u The user name for the vCenter server.
p The user password for the vCenter server.
h The IP address of the ESXi host.
WWPN The WWPN of a port.
BeaconState New state of the beacon:
0 = Off
1 = On
BeaconDuration (Optional) On supported adapters, specifies the amount of time, in seconds,
beaconing is enabled.
0 - 65535 (seconds)
0 = Infinite (default)
v The vCenter server IP address.
u The user name for the vCenter server.
p The user password for the vCenter server.
h The IP address of the ESXi host.
WWPN The WWPN of the port.
FileName The name of the .dpv file (stored in the Emulex Repository directory)
Flag G = Makes change global (all adapters on this host)
N = Makes change non-global (adapter-specific)