Users Guide

Broadcom BT-FC-LPE-UG124-100
26
Emulex Boot for the Fibre Channel Protocol User Guide
Figure 11: Adapter Configuration Menu for LPe35002 Adapters
Default settings are acceptable for most installations.
To reset all values to their defaults, from the main configuration menu (Figure 2), select Reset Adapter Defaults and press
Enter.
4.4.1 Changing the Default AL_PA
NOTE: This option is available only on the LPe12000-series and LPe16000-series adapters and is not available on the
LPe31000-series and LPe32000-series adapters.
The default value of the AL_PA for the adapter BIOS is 00 (hexadecimal). All adapters or boot drives can be configured to
other AL_PAs rather than their default values.
NOTE: This option applies only to FC-AL.
To change the default AL_PA, perform these steps:
1. From the main configuration menu (Figure 2), select Configure Advanced Adapter Parameters.
The adapter configuration menu is displayed (Figure 10).
2. Select Change Default ALPA of this Adapter and press Enter.
Information similar to Figure 12 is displayed.