Users Guide

Broadcom BT-FC-LPE-UG124-100
53
Emulex Boot for the Fibre Channel Protocol User Guide
6.6 Scanning for Fibre Devices
NOTE:
 After you enter the Emulex Configuration utility using HII, any dynamic changes made to the SAN are not
reflected unless the system is reset or the adapter is reconnected.
 For trunking SAN changes, the system must be reset. Re-enter the utility and perform a scan.
 The adapter link is brought up by either performing a scan for Fibre devices or by configuring boot devices.
To scan for Fibre devices, perform these steps:
1. From the Device Configuration screen (Figure 27), select the adapter that you want to scan for Fibre devices and press
Enter.
2. From the Main menu (Figure 28), select Scan for Fibre Devices and press Enter.
A list of the discovered targets is displayed (Figure 31). This is only a list of discovered target devices to determine SAN
connectivity.
Figure 31: Discovered Targets Screen