Users Guide

Broadcom BT-FC-LPE-UG124-100
79
Emulex Boot for the Fibre Channel Protocol User Guide
Figure 56: Legacy Only Configuration Settings Screen
3. Make the desired changes to any of these settings and select Esc or Commit Changes.
See Chapter 4, Emulex BIOS (x86) Utility for a description of the legacy-only settings displayed in Figure 56.
6.14 Requesting a Reset or Reconnect
NOTE: This feature is not available for LPe12000-series adapters.
After you have made changes to the UEFI BIOS, you might need to reset or reconnect the adapter for the changes to take
effect. Reset or Reconnect is disabled by default, and you must enable it if you want the adapter to automatically reset or
reconnect. Otherwise, the changes do not take effect until you manually reboot the server.
Reset forces the system to reboot after you exit the UEFI Boot (HII) utility.
Reconnect unloads and reloads the driver. This allows any changes to take effect immediately without requiring a reboot.
The Reconnect feature also requires UEFI 2.5-compliant BIOS to enable this functionality. If the server BIOS is not
UEFI 2.5-compliant, this option will be unavailable (grayed-out).
Trunking configuration changes cannot be activated with a reconnect. A system reboot is required.
To request a reset or reconnect, perform these steps:
1. From the Device Configuration screen (Figure 27), select the adapter that you want to reset or reconnect and press
Enter.
2. From the Main menu (Figure 28), select Request RESET or RECONNECT to Make Changes Active.
The Request RESET or RECONNECT to Make Changes Active screen appears (Figure 57).