Users Guide

Broadcom DRVLin-LPe-UG124-100
80
Emulex Drivers for Linux User Guide
elx_ msg1050: Authentication mode is disabled, but is required by the fabric
Discovery failed because the switch fabric required authentication, but either authentication was not configured or the authentication
mode for this port pair is disabled.
Data: None
Severity: Error
Log: LOG_SECURITY
Action: Configure the driver to authenticate with the switch or disable authentication on the switch to this port.
1053: Start Authentication: Security service offline
The authentication failed because security service was unavailable.
Data: None
Severity: Error
Log: LOG_SECURITY
Action: Software driver error. If this issue persists, report errors to Broadcom Technical Support.
1055: Authentication parameter is disabled, but is required by the fabric
FLOGI failed because the fabric indicated that authentication is required, but authentication is not yet configured or enabled on the HBA.
Data: None
Severity: Error
Log: LOG_SECURITY
Action: Configure authentication on this HBA.
1057: Authentication transaction reject. reason <reason> exp <explanation>
An authentication was rejected and requested again due to the reason as displayed with the explanation.
Data: (1) reason (2) explanation.
Severity: Error
Log: LOG_SECURITY
Action: Software driver error. If this issue persists, report errors to Broadcom Technical Support.
1058: Waiting for authentication service
A delay occurred when the authentication service was not initially available as expected.
Data: None
Severity: Warning
Log: LOG_SECURITY
Action: Software driver warning. If this issue persists, report these errors to Broadcom Technical Support.
1059: Authentication became available
The authentication service came online, but it was not initially available as expected.
Data: None
Severity: Warning
Log: LOG_SECURITY
Action: Software driver warning. If this issue persists, report these errors to Broadcom Technical Support.
1201: Failed to allocate dfc_host
Failed to allocate memory for the dfc_host_struct.
Data: None
Severity: Error
Log: LOG_ELS
Action: None required.
Table 7: LPFC Error Log Messages and Their Descriptions (Continued)