Users Guide
Table Of Contents
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Configuration
- 3.1 ESXi Command Line Tool Transition
- 3.2 FC Driver Configuration
- 3.2.1 Configuration Methods for FC Driver Parameters
- 3.2.2 Emulex ExpressLane Support
- 3.2.3 FC-SP-2 Authentication (DH-CHAP) Support
- 3.2.4 Trunking Support
- 3.2.5 Dynamically Adding LUNs
- 3.2.6 Dynamically Adding Targets
- 3.2.7 FC Driver Module Parameters
- 3.2.8 Creating an FC Remote Boot Disk
- 3.2.9 Managing Devices through the CIM Interface
- 3.2.10 Installing the Emulex CIM Provider
- 3.2.11 Creating, Deleting, and Displaying vPorts
- 3.2.12 Configuring VVols
- 3.2.13 Adjusting the LUN Queue Depth
- 3.3 Configuring NVMe over FC on a NetApp Target
- 3.4 Configuring NVMe over FC on an Initiator System
- Chapter 4: Troubleshooting the FC Driver
- Chapter 5: Troubleshooting the NVMe Driver
- Appendix A: esxcli Management Tool
- Appendix B: lpfc Driver BlockGuard Functionality
- Appendix C: Using the VMID Feature on a Brocade Switch
- Appendix D: Using the VMID Feature on a Cisco Switch
- Appendix E: NPIV Configuration
- Appendix F: License Notices
Broadcom DRVVM-UG128-100
88
Emulex Drivers for VMware ESXi User Guide
0390 iotag <iotag> does not map to outstanding IO. last cmd <ulpCommand>, XRI <sli4_xritag>, wqidx
<fcp_wqidx>, flag <iocb_flag>
The I/O tag does not map to the outstanding I/O list of the driver.
ACTION: This error could indicate a software driver, firmware, or a hardware issue. Report the error to Broadcom Technical Support.
1807 IOCB <> failed. No vport
The IOCB does not have the vPort reference in it.
ACTION: This is a software issue. Report the error to Broadcom Technical Support.
6771 PCIe Read from <addr> succeeded after <retry_cnt> attempts
The PCIe read of an address succeeded after certain number of attempts.
ACTION: No action required.
2402 Failed to allocate xri for ELS sgl
Failed to allocate XRI for the Extended Link Service command.
ACTION: This is a software driver error. If this issue persists, contact Broadcom Technical Support.
6114 Allocate <bcnt> out of <num_to_alloc> requested new IO buffers
Number of I/O buffers allocated.
ACTION: No action required.
6134 insufficient XRI <io_xri_max> xri_split <cfg_xri_split>
Insufficient XRI for I/O pool. The driver retries with reduced I/O pool size.
ACTION: The driver should recover from this situation. If the port does not come up, report the error to Broadcom Technical Support.