Users Guide

Broadcom BT-FC-UG128-100
51
Emulex Boot for the Fibre Channel Protocol User Guide
4.8 Resetting the Adapter to Default Values
NOTE: Resetting the adapter to default values clears all entries made while configuring the boot device, as detailed in
Section 4.5, Configuring Boot Devices.
The Emulex LightPulse FC BIOS utility enables you to reset boot code parameters to their factory default settings. These
defaults are listed in Table 5.
Table 5: Boot Code Defaults
Parameter Default Valid Values
Boot from SAN Disabled  Enabled
 Disabled
ALPA Value 0x01 Fibre See the ALPA reference table in
Section 4.6.1, Changing the Default AL_PA.
EDD 3.0 EDD 3.0
 Disabled (EDD 2.1)
 Enabled (EDD 3.0)
PLOGI Retry Timer Disabled
 Disabled
 50 ms
 100 ms
 200 ms
Spinup Delay Disabled  Enabled
 Disabled
Auto Scan Disabled
 Enabled
 Disabled
Start Unit Disabled
 Enabled
 Disabled
Environmental Variable Disabled  Enabled
 Disabled
Auto Boot Sector Disabled
 Enabled
 Disabled
Brocade FA-PWWN Disabled
 Enabled
 Disabled
Trunking Disabled  4-Lane Trunk
 2-Lane Trunk
 Disabled
Topology Auto Topology: Loop First (for LPe12000-series
adapters)
Auto Topology: Loop First (for LPe16000-series
adapters
Point-to-point (for LPe31000-series,
LPe32000-series, and LPe35000-series adapters)
 Auto Topology: Loop First (default)
 Auto Topology: Point-to-Point First
 FC-AL
 Point-to-Point
Link Speed AutoSelect (highest successfully negotiated speed) —
16G Forward Error
Correction
Enabled
 Enabled
 Disabled