Users Guide

Broadcom BT-FC-UG128-100
63
Emulex Boot for the Fibre Channel Protocol User Guide
6.6 Adding Boot Devices
NOTE: After you enter the UEFI HII, any dynamic changes made to the SAN are not reflected unless the system is reset
or the adapter is reconnected.
NOTE: The adapter link is brought up by either adding a boot device or by performing a scan for Fibre devices.
To add a boot device, perform these steps:
1. From the adapter list (Figure 31), select the adapter to which you want to add a boot device and press Enter.
2. From the main configuration menu (Figure 32), select Add Boot Device and press Enter.
The SAN Discovery Target List windows is displayed. (Figure 35).
3. Select the target you want and press Enter.
A list of bootable LUNs is displayed (Figure 36)
Figure 36: Bootable LUNs
4. Select the boot device you want to add and press Enter.
You are prompted to commit or discard your changes (Figure 37).