Manual

Boot Version 10.2 for NIC, iSCSI, FCoE, and RoCE Protocols User Manual P010097-01B Rev. A
3. Configuring PXE Boot for NIC on OCe14000-series Adapters
PXE Boot Parameters Default Values
1556
PXE Boot Parameters Default Values
The default settings for the PXE Boot parameters are listed in the following table.
Table 3-1 PXE Boot Parameter Default Values
Parameter Default Value Valid Values
Multichannel The default for this parameter varies
depending on the vendor
configuration.
For Emulex adapters:
•Enabled
•Disabled
For IBM adapters:
•IBM Virtual Fabric Mode
• IBM Unified Fabric Protocol Mode
• Switch Independent Mode
•Disabled
Personality The default for this parameter varies
depending on the vendor
configuration.
When multichannel is enabled:
•NIC
• iSCSI
•FCoE
•Custom
When multichannel and SR-IOV are
disabled:
•NIC
• iSCSI
•FCoE
•NIC+RoCE
Note: RoCE is supported on Windows
only.
When multichannel is disabled and
SR-IOV is enabled:
•NIC
• iSCSI
•FCoE
SR-IOV Disabled Enabled
Disabled
RoCE Profile
Note: This setting is
only available
when the
NIC+RoCE
personality is
selected.
RoCE-1 RoCE-1
RoCE-2
Minimum Bandwidth 0% Must have a total of 100% across all
ports.
Maximum Bandwidth 0% From the minimum bandwidth value up
to 100% (inclusive).
LPVID 0 2–4094