Setup Guide

Broadcom DRVWin-LPE-UG124-100
11
Emulex Drivers for Windows User Guide
2.3.2.1 Option 1: Automatically Run AutoPilot Installer
Use this option unless you have specific configuration requirements.
1. Double-click the driver kit or run it from a command line. The command line parameter APargs allows you to specify
arguments that are automatically passed to the AutoPilot Installer command.
A Welcome window is displayed with driver kit version information and Emulex contact information (see Appendix B,
AutoPilot Installer Command Line and Configuration File Parameters, for additional information on command line
installations).
2. Click Next to proceed to the Installation Options window.
For each installation option, the default installation location for that option is displayed. Browse to a different location, if
desired.
3. Click Install to continue the installation.
The Progress dialog is displayed.
After all tasks complete, a Finish window is displayed. Start AutoPilot Installer is automatically selected.
4. Click Finish.
AutoPilot Installer runs automatically and completes one of the following installations:
– Section 2.3.3, Hardware-First Installation or Driver Update
– Section 2.3.4, Software-First Installation
2.3.2.2 Option 2: Run AutoPilot Installer Separately
To access these options, run AutoPilot Installer after the driver kit loading has been completed, which allows you to change
the configuration options supplied to AutoPilot Installer.
1. Perform Step 1 through Step 3 in Option 1: Automatically Run AutoPilot Installer.
2. Clear Run AutoPilot Installer on the Finish dialog.
3. Click Finish.
The driver kit installer exits.
After the driver kit loading is complete, change the configuration in one of two ways:
– Change the configuration file.
– Supply parameters on the command line.
NOTE: See Appendix B, AutoPilot Installer Command Line and Configuration File Parameters, for additional information
on either of these configuration methods.
After you have finished this step, you can run AutoPilot Installer at a later time.
4. Run AutoPilot Installer using the following command:
C:\Program Files\Emulex\AutoPilot Installer\APInstall.exe
NOTE: The location of APInstall.exe might differ on your system, depending on your system's Program Files location.
You can also specify a different location when you install the driver package.