White Papers

8.14 Profile Conventions for Operations
Support for operations for each profile class (including associations) is specified in the following
subclauses. Each subclause includes either the statement “All operations in the default list in section 8.14
are supported as described by DSP0200 version 1.2” or a table listing all of the operations that are not
supported by this profile or where the profile requires behavior other than that described by DSP0200.
The default list of operations is as follows:
 GetInstance
 EnumerateInstances
 EnumerateInstanceNames
 Associators
 AssociatorNames
 References
 ReferenceNames
A compliant implementation shall support all of the operations in the default list for each class, unless the
“Requirement” column states something other than Mandatory.
9 Use Cases
This section contains use cases for the Dell RAID Profile.
Note that URIs in this section are in form of WBEM URIs for WinRM
®
.
9.1 Discovery of RAID profile support
Use one of the two procedures below to confirm the existence of RAID profile support
A) GET the DCIM_LCRegisteredProfile instance using an InstanceID of DCIM:SimpleRAID:1.0.0.
See section 3.6 for a definition of GET.
Instance URI:
http://schemas.dmtf.org/wbem/wscim/1/cim-
schema/2/DCIM_LCRegisteredProfile?__cimnamespace=root/interop+InstanceID=DCIM:Simple
RAID:1.0.0
Results for the InstanceID of DCIM:SimpleRAID:1.0.0 shown below. If no instance is returned, the
profile is not supported.
DCIM_LCRegisteredProfile
AdvertiseTypeDescriptions = WS-Identify, Interop Namespace
AdvertiseTypes = 1, 1
InstanceID = DCIM:SimpleRAID:1.0.0
OtherRegisteredOrganization = DCIM
RegisteredName = Simple RAID
RegisteredOrganization = 1