White Papers

16 Version 1.2.3
Difference Broadcom QLogic
MinBandwith
If the MinBandwidth attribute(s) are set, the total sum of all the MinBandwidth attributes for all
partitions on a port must add up to 0 or 100 at the conclusion of set operation. For example, if the
MinBandwidth needs to be changed to 50 on partition 1, then the Minbandwidth must be changed
on other partition(s) to make sure the MinBandwidth for all partitions on the port adds to a 100.
Port
Partition
Current
Minbandwidth
New
Minbandwidth
1 30 50
2
30
20
3
20
20
4
20
10
If the Minbandwidth does not add up to 0 or 100, then USC advanced configuration may not set
any other attribute until this error condition of MinBandWidth is rectified. USC Advanced
Configuration does not notify about this error condition.
Note: MinBandwidth summation can be done independently through USC Advanced
Configuration or through Remote Services interface that is used by WSMAN
clients.
NicPartitioning
and partition
specific
attributes
After NicPartitioning attribute is disabled, partition specific
attributes (Seethe following table) does
not exist anymore. Therefore, do not
disable NicPartitioning attribute and set
partition specific attributes together, and
then invoke the
CreateTargetedConfigJob() method.
Partition specific attributes
MinBandwidth
MaxBandwidth
NicMode
iScsiOffloadMode
FCoEOffloadMode
VirtMacAddr
VirtIscsiMacAddr
VirtFIPMacAddr
VirtWWN
VirtWWPN
Not applicable as NicPartitioning
cannot be
disabled in
QLogic.