Deployment Guide

17 VxRail Networking Guide with Dell EMC S4148-ON Switches | version 1.0
3.2.4 Unified ports on the S4148U
This section only applies to the S4148U switch. Skip this section if using other S4148 switches (S4148F,
S4148FE, and S4148T). To configure unified ports on S4148U switches to Ethernet ports. Refer to the switch
user’s guide for further details.
Port-group 1/1/1-1/1/6 refers to the first 24 SFP+ ports on the switch. Use the following commands to convert
these ports to Ethernet ports.
Switch-1# configure terminal
Switch-1(config)# port-group 1/1/1
Switch-1(conf-pg-1/1/1)# mode Eth 10g-4x
Switch-1(conf-pg-1/1/1)# exit
Switch-1(config)#
Note: QSFP+ and QSFP28 ports are by default in Ethernet mode. They can be configured by configuring
port-group 1/1/7-1/1/10 using the previous commands. Refer to the OS10 Enterprise User Guide for more
information.
Repeat the prior steps for port-group 1/1/2 to 1/1/6.
3.2.5 Verify license installation
OS10# show license status
Switch-1# show license status
System Information
Vendor Name : Dell EMC
Product Name : S4148F-ON
Hardware Version: A00
Platform Name : x86_64-dellemc_s4148f_c2338-r0
PPID : CN09H9MN2829875P0042
Service Tag : JLP6XC2
License Details
----------------
Software : OS10-Enterprise
Version : 10.4.0E(R2)
License Type : PERPETUAL
License Duration: Unlimited
License Status : Active
License location: /mnt/license/JLP6XC2.lic