Deployment Guide

27 VxRail Networking Guide with Dell EMC S4148-ON Switches | version 1.0
2. Configure Switch 2 using the commands in column 2 for Switch-2
4.4.4 Network facing uplink configuration - 4 x 10GbE breakout ports
QSFP+ and QSFP28 ports on S4148-ON switches can be configured as breakouts with 10GbE uplink ports.
To configure these ports as 4 x 10GbE ports, use the following commands.
1. Configure interface breakout node/slot/port map {10g-4x | 25g-4x | 40g-1x | 50g-2x | 100g-1x}
Switch-1(config)# interface breakout 1/1/25 map 10g-4x
Switch-1(config)# exit
Switch-1#
2. Verify the port status with the following command:
Switch-1(config)# do show interface status
----------------------------------------------------------------------
Port Description Status Speed Duplex Mode Vlan Tagged-Vlans
----------------------------------------------------------------------
Eth 1/1/25:1 down 0 auto A 1 -
Eth 1/1/25:2 down 0 auto A 1 -
Eth 1/1/25:3 down 0 auto A 1 -
Eth 1/1/25:4 down 0 auto A 1 -