White Papers

Version 1.4.0 29
MessageID (OUT parameter) Message MessageArguments[]
OSD37 ISO image size too large
OSD40 VFlash is not Dell-licensed
OSD42
Downloading ISO File to VFlash
failed
OSD43 VFlash unavailable
OSD47 Inaccessible network share
OSD48
ISO Image more than 4GB not
supported
OSD52 VFlash is Disabled
OSD53 VFlash is write-protected
OSD54 VFlash already has 16 partitions
OSD55 ISO Image is attached to host
481
8.10 DCIM_OSDeploymentService.BootToISOFromVFlash() 482
The BootToISOFromVFlash() method is used to boot to the downloaded pre-operating system image on 483
the vFlash SD card. The following table lists the return values for BootToISOFromVFlash() method, where 484
the method-execution behavior matches the return-code description. 485
Table 35 – DCIM_OSDeploymentService.BootToISOFromVFlash() Method: Return Code Values 486
Value Description
2 Error occurred.
4096
Job started: REF returned to started
CIM_ConcreteJob
The following table list the BootToISOFromVFlash() method. 487
Table 316 – DCIM_OSDeploymentService.BootToISOFromVFlash() Method: Parameters 488
Qualifiers Name Type Description/Values
OUT, REQ Job CIM_ConcreteJob REF Returned to keep track of the created job.
OUT MessageID String
If the method fails to execute, the error
message ID is returned.
OUT Message String
If the method fails to execute, the error
message in English is returned.
OUT
MessageArgument
s[]
string
Substitution variables for dynamic error
messages
Table 37 – DCIM_OSDeploymentService.BootToISOFromVFlash() Method: Standard Messages 489
MessageID (OUT parameter) Message MessageArguments[]
OSD1 The command was successful
OSD3
Lifecycle Controller is being used
by another process
OSD9
Failed to reboot the system using
IPMI command