White Papers

Version 1.2.0 33
MessageID (OUT parameter) Message MessageArguments[]
SYS007 Input out of range for <parameter> AttributeName
SYS008
Invalid boolean in AttributeValue
for AttributeName <parameter>
AttributeName
SYS009
String exceeds maximum length for
AttributeName <parameter>
AttributeName
SYS010
Invalid character in AttributeValue
for AttributeName <parameter>
AttributeName
SYS011
Configuration already committed,
cannot set configuration
SYS012
User is not Authorized to perform
this operation
SYS013 Invalid AttributeName <parameter> AttributeName
SYS014
Invalid AttributeValue for
AttributeName <parameter> AttributeName
SYS015 Job created
SYS016 Job completed with errors
SYS017 Job failed
SYS018 Job completed
SYS019
Required dependancy input not
found
SYS020 Invalid Required Attribute value
SYS023 No pending configurations
SYS024 Attribute dependency failed
505
8.4 DCIM_SystemManagementService.DeletePendingConfiguration() 506
The DeletePendingConfiguration() method is used to cancel the pending values created by the 507
SetAttribute and SetAttributes methods. The DeletePendingConfiguration() method cancels the pending 508
configuration changes made before the configuration job is created with CreateTargetedConfigJob(). This 509
method only operates on the pending changes prior to CreateTargetedConfigJob() being called. After the 510
configuration job is created, the pending changes can only be canceled by calling DeleteJobQueue() 511
method in the Job Control profile. 512
Return code values for the DeletePendingConfiguration() method are specified in Table 30, and 513
parameters are specified in Table 31. 514
Table 30 – DeletePendingConfiguration() Method: Return Code Values 515
Value Description
0 Completed with no error
2 Failed
Table 31 – DeletePendingConfiguration() Method: Parameters 516
Qualifiers Name Type Description/Values
IN, REQ Target String
Shall be equal to “System.Embedded.1”