White Papers

103 Lifecycle Controller Integration Best Practices Guide
RegisteredOrganization = 1
RegisteredVersion = 1.2.0
14.2 Inventory of RAID Controllers in System
Use the following procedure below to list the inventory of all RAID controllers in the system.
Applies to: LC1.5.0+
Prerequisites for script: none
Script: GetRAIDControllerViews.win
A) The Lifecycle Controller remote service must be in a “ready” state before running any other WSMAN commands.
The GetRSStatus() method or the GetRemoteServicesAPIStatus() method may be used depending on the version of the
LC Management registered profile.
B) GetControllerViews(): ENUMERATE the DCIM_ControllerView class to view all instances. See section 2.2 for a
definition of ENUMERATE.
The instance information of all available RAID controllers will be returned.
14.3 Get Information About the First RAID Controller
Use the following procedure to get a single RAID controller instance. The URI for getting particular instance
information is deterministic (i.e the InstanceID will be unique for each instance).
Applies to: LC1.5.0+
Prerequisites for script: Set desired instanceID by editing script
Script: GetRAIDControllerView.win
A) The Lifecycle Controller remote service must be in a “ready” state before running any other WSMAN commands.
The GetRSStatus() method or the GetRemoteServicesAPIStatus() method may be used depending on the version of the
LC Management registered profile.
B) GetControllerView(): GET the DCIM_ControllerView instance using the desired instanceID. See Section 2.3 for a
definition of GET.
The instance of DCIM_ControllerView that contains the information on the first RAID controller will be returned.
14.4 Inventory of Virtual and Physical Disk Drives in System
Use the following procedure below to list the inventory of all virtual disks and physical disks in the system.
Applies to: LC1.5.0+