White Papers

140 Lifecycle Controller Integration Best Practices Guide
27.2 Inventory of Power Supplies in System
Use the following procedure below to list the inventory of all power supplies in the system.
Applies to: LC1.5.0+
Prerequisites for script: none
Script: GetPowerSupplyViews.win
A) The Lifecycle Controller remote service must be in a “ready” state before running any other WSMAN commands.
The GetRSStatus() method or the GetRemoteServicesAPIStatus() method may be used depending on the version of the
LC Management registered profile.
B) GetFanViews(): ENUMERATE the DCIM_PowerSupplyView class to view all instances. See section 2.2 for a
definition of ENUMERATE .
The instance information of all available power supplies will be returned.
27.3 Get Information About the First Power Supply
Use the following procedure to get a single power supply instance. The URI for getting particular instance information is
deterministic (i.e the InstanceID will be unique for each instance).
Applies to: LC1.5.0+
Prerequisites for script: Set desired instanceID by editing script
Script: GetPowerSupplyView.win
A) The Lifecycle Controller remote service must be in a “ready” state before running any other WSMAN commands.
The GetRSStatus() method or the GetRemoteServicesAPIStatus() method may be used depending on the version of the
LC Management registered profile.
B) GetPowerSupplyView(): GET the DCIM_PowerSupplyView instance using the InstanceID=PSU.Slot.1. See Section
2.3 for a definition of GET.
The instance of DCIM_PowerSupplyView that contains the information on the first power supply will be returned.
27.4 Get MAC Information
This workflow enumerates DCIM_SystemView and invokes GetMACInfo.
Applies to: LC1.5.0
Prerequisites for script: none
Script: CollectBlades.win